Adobe Premiere Elements 8 Manual de usuario descargar pdf (Pagina 203)

198

USING ADOBE PREMIERE ELEMENTS 8 EDITOR

Applying effects

Last updated 8/12/2010

Fill Left, Fill Right

The Fill Left effect duplicates the left channel information of the audio clip and places it in the right channel, discarding

the original clip’s right channel information. The Fill Right effect duplicates the right channel information and places

it in the left channel, discarding the existing left channel information. For example, you might use this effect on footage

shot with a monaural microphone plugged into only one channel of a camcorder, extending the voice of a speaker from

one channel to both.

Highpass, Lowpass

The Highpass effect removes frequencies below the specified Cutoff frequency. Use it to reduce low-pitched noises and

rumbles.

The Lowpass effect eliminates frequencies above the specified Cutoff frequency. Use it to eliminate high-pitched

noises, squeals, and whistles.

Invert

The Invert effect inverts the phase of all channels. Use it, for example, to bring the sound of one shot of an event into

phase with another shot of the same event taken from another camcorder.

Notch

The Notch effect removes frequencies that are near the specified center. The Center control specifies the frequency to

be removed. If you are removing power-line hum, type a value that matches the power-line frequency used by the

electrical system where the clip was recorded. For example, in North America and Japan, type 60 Hz, and in most other

countries, type 50 Hz.

PitchShifter

The PitchShifter effect adjusts the pitch of the incoming signal. Use this effect to deepen high voices or vice versa. You

can adjust each property by using graphical controls in the Custom Setup view, or by changing the Individual

Parameters values.

Pitch Specifies the change in pitch in semitone steps. The adjustable range is between -12 and +12 semitones.

FineTune Fine tunes the semitone grid.

Formant Preserve Prevents formants in the audio clip from being affected. For example, use this control when

increasing the pitch of a high voice to prevent it from sounding cartoon like.

Reverb

The Reverb effect adds ambience and warmth to an audio clip by adding the reverberation the sounds might have had

recorded in a “live” room. Click the triangle beside the Custom Setup button to view the following options:

PreDelay Specifies the time between the signal and the reverberation. This setting correlates to the distance a sound

travels to the reflecting walls and back to the listener in a live setting.

Use the graphical controls in the Custom Setup view, or adjust the Individual Parameters values.

Absorption Specifies the percentage in which the sound is absorbed.

Size Specifies the size of the room as a percentage.

Density Specifies the density of the reverb “tail.” The Size value determines the range in which you can set Density.

Lo Damp Specifies the amount of dampening for low frequencies (in decibels). Dampening lower frequencies prevents

the reverb from rumbling or sounding muddy.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 312 313

Sin comentarios

Adobe Premiere Elements 8 Manual de usuario Pagina 203